Sparkle ATX-300GT 300W P4 ATX Power Supply, Bulk
	Mfr Part Number: ATX-300GT-B Feature: Ball Bearing 300W P4 ATX (20pin/4pin)(Intel & AMD website listed) Complied with ATX and ATX12V standard High efficiency and reliability Remote On/Off function Internal 12V DC fan included Noise Killer (Thermal fan speed control function) Low noise and ripple Complies with FCC part 15 subpart J class B and CISPR 22 Class B Output over voltage, short circuit, and over current protection 100% Hi-pot, ATE, and burn-in tested Re-settable power shut down Approved by UL 1950, CSA C22.2 Level 3, TUV EN60950,Nemko (CB Report) With I/O (On/Off) switch Input Characteristics Input Range: 95~132/180~264V AC, Manual-select Frequency: 47~63Hz Input Current: 10A (RMS) @115V AC, 5A (RMS) @230VAC Inrush Current: 80A Max for 132V AC Cold Start Output Characteristics +5V and +3.3V total output not exceed 175W When +3.3V is load to 20A, the +5V maximum load is 21.8A When +3.3V is load to 7.5A, the +5V maximum load is 30A +3.3V, +5V, and +12V total output not exceed 280W Dielectric Withstand: Primary to frame ground 1800V AC for 1 second Efficiency: 65% at minimum measured at nominal AC main voltage and frequency with maximum load on all output Rise Time: Less than 20 ms on all outputs Hold-up Time: 16ms minimum at 115V/60Hz; 20 ms minimum at 230V/50Hz input voltage Power Good Signal: Power on delay time 100 ms to 500 ms, off delay 1ms minimum (TTL and CMOS compatible) Leakage Current: Less than 3.5mA Dimension(WxDxH): 5.9 x 5.5 x 3.4 inch / 150 x 140 x 86 mm